Why would someone take the time to send me that question I’ll never know. That said, rather than sending an email reply I thought I’d post it instead. There must be lots of other drivers out there that probably want to tie their body kits into a knot too. Surely there is absolutely nothing else to do, so lets try it..
It turns out that in some instances it is quite possible to do so without harming the part depending on the body kit part that you are working with, and it would obviously depend on the knot. So can I tie it into a:
- Square Knot? – NO
- Figure Eight? – NO
- Overhand? – Well, read on…
Lets take a urethane Air Dam – it is very flexible and if you twist it into a million directions it wont break or crack, so I would say YES you can tie your air dam or probably even your side skirts in a pretzel shaped overhand knot. Let me just say at this point that i think you would probably be the only person that I know that has a knotted body kit, so good for you 
. However if it were fiberglass you would never be able to do that. Fiberglass parts are not flexible and if you try to bend them like that they will crack or break in half. Thats why people buy urethane body kits, for the flexibility alone. To prove the point we took a urethane front air dam (lip) by Wings West that was for an Acura Integra and took before and after pictures.
Here it is tied into a knot:
Here it is after we untied it:
